5
3. WB CONTROL
• AUTO: Controls the automatic adjustment of the light source’s color temperature from 3,000°K
~ 8,000°K.
• ATW: Continuously adjusts camera color balance in accordance with any change in color
temperature. Compensates for color temperature changes within the range of 1,900°K to
11,000°K.
• PUSH: Color temperature will be manually adjusted by pushing the OSD button. Place the
white paper in front of the camera when OSD button is pressed to obtain optimum result.
• MANUAL: Select this to fine-tune White Balance manually.
• You can adjust the blue and red tone level manually.
1. BLUE: Adjust the Blue tone of the image. (0~20)
2. RED: Adjust the Red tone of the image. (0~20)
• INDOOR: Select this to adjust white balance to indoor lighting condition.
• OUTDOOR: Select this to adjust white balance to outdoor lighting condition.
WB CONTROL
AE CONTROL
DAY/NIGHT
AUDIO
IMAGE CONTROL
SPECIAL
SETUP
RESET
EXIT
MODE
BLUE
RED
RETURN
MANUAL
>
AUTO>
>
>
OFF
>
ON>
PUSH
10
10
>
MENU WB CONTROL
1. Adjust White Balance first by using the AUTO or ATW mode before switching to MANUAL
mode.
2. White Balance may not work properly under the following conditions. In this case, select the
ATW mode.
• When the ambient illumination of the subject is dim.
• If the camera is directed towards a fluorescent light or installed in a place where
illumination changes dramatically, the White Balance operation may become unstable.
Select WB CONTROL using the UP or DOWN button. You can change between AUTO, ATW, PUSH,
and MANUAL using the LEFT or RIGHT buttons.
To Next Page
Loading...
Need help?
General