EasyManua.ls Logo

Marshall Amplification DSL20HR - Front Panel Functions; Classic Gain Channel; Ultra Gain Channel; Equalisation Section

Marshall Amplification DSL20HR
7 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
emulation. This ensures that your
headphone and output signal from this
socket provide the best possible tone for
practice or recording.
Note: For silent recording via EMULATED
OUT set the OUTPUT switch to STB (Front
Panel Function #14).
Important: Using EMULATED OUT does
not omit the need for a speaker load to be
connected (See Rear Panel Function #22).
22. LOUDSPEAKERS
There are three speaker cabinet output
jack sockets available. They are labelled
according to the intended impedances:
1 x 16 OHM: Connect a single 16
Ohm speaker cabinet to this jack.
1 x 8 OHM or 2 x 16 OHM: Connect
a single 8 Ohm speaker cabinet or
two 16 Ohm speaker cabinets.
WARNING - Although the amplier has
three speaker outputs, never attempt
to connect more speaker cabinets than
rated. The safe combinations are: 1 x 8
Ohm speaker cabinet, 2 x16 Ohm speaker
cabinets or 1 x 16 Ohm speaker cabinet.
Any other speaker cabinet conguration
may stress the power amplier section and
in extreme cases may lead to valve and/
or output transformer failure. NEVER use
DSL20HR or DSL20CR without a speaker
load.
16. MAINS INPUT
Connects the amplier to the mains
electricity supply.
Note: The MAINS INPUT socket has an
integrated fuse compartment. Ensure that
the value of a replacement fuse matches the
labelling on the amplier rear panel. You
MUST ALWAYS switch the amplier OFF
and disconnect it from the mains electricity
supply before attempting to access the fuse
compartment. If in doubt, contact your
Marshall dealer.
17. FX LOOP RETURN
Connect the output of an external FX
pedal or processor.
18. FX LOOP SEND
Connect the input of an external FX
pedal or processor.
19. F/S
Connect the supplied 2-way CHANNEL
and FX LOOP footswitch here (PEDL-
90012).
20. AUDIO IN
Connect an external device here for
practice or to jam along with music.
21. EMULATED OUT
Frequency compensated line level
output for headphones or for connection
to a mixer. The DSL is equipped with
a high quality emulated output using
Softube-designed studio cabinet
REAR PANEL FUNCTIONS
DSL20CR REAR PANEL
DSL20HR REAR PANEL
ENGLISH
16
16 17 18 19 20 21
22
171819202122

Other manuals for Marshall Amplification DSL20HR

Related product manuals