ENGLISH
5
1 Mains Input Connector
Your AVT20 is provided with a detachable
mains (power) lead which is connected here.
The specific mains input voltage rating that
your amplifier has been built for is shown on
the back panel. Before connecting for the first
time, please ensure that your electricity supply
is compatible with your amplifier. If you have
any doubt, please get advice from a qualified
person. Your Marshall dealer will help in this
respect.
AVT20 1x10" Combo Front Panel Features
B) The tone of your sound is also dependent
on the settings of the ‘tone’ controls, and
adjusting them to taste will further enhance the
sonic textures of your AVT20. The best way to
achieve your desired settings is to experiment.
6 Reverb Depth Control
Your AVT20 is fitted with an internal spring
Reverb unit. This control affects the mix of the
direct (dry) and Reverb signals - the higher this
control is set, the greater the Reverb depth.
7 CD Input Jack Socket
The CD input will take a stereo signal from
an external source, such as a CD or tape
player, and mix it into a mono format. This will
allow you to play along with a pre-recorded
signal. Because this input is after the preamp
stage, its volume has to be controlled from your
CD or tape player.
8 Emulated DI Out Jack Socket
This jack socket carries a specially treated
output signal from your AVT20 which accurately
emulates the sonic signature of a guitar
loudspeaker. This output can be used in both
live performance and recording situations to
achieve authentic guitar amp tones without
having to use a microphone. Furthermore, if
you wish to mute the loudspeaker, for ‘silent’
recording, then merely insert an unused jack
plug (a short patch cable will do fine) or a set of
headphones into the Headphone socket.
9 Headphone Jack Socket
In addition to providing a specially filtered
output signal for a set of headphones, this jack
also disconnects the main loudspeaker,
enabling you to practice in ‘silence’.
10 External Speaker Jack Socket
This socket allows you to connect your
AVT20 into an external loudspeaker system,
provided it has an impedance of 8 or 16 ohms.
By using any one of our comprehensive range
of extension cabinets, you will be able to
unleash the massive amount of tonal options
that extra loudspeakers will provide.
AVT20 1x10" Combo Rear Panel Features
To Next Page
Loading...
Need help?
General
