Martel MC1000 - Page 7

5
Caution
To avoid possible damage to calibrator or
to equipment under test:
• Disconnect the power and discharge all high-
voltage capacitors before testing resistance
or continuity.
• Use the proper jacks, function, and range for
your measurement or sourcing application.
• To avoid mechanically damaging the pressure
module, never apply more than 10 ft-lb. of
torque between the pressure module fittings,
or between the fittings an the body of the
module.
• To avoid damaging the pressure module from
overpressure, never apply pressure above the
rated maximum printed on the module.
• To avoid damaging the pressure module from
corrosion, use it only with specified materials.
Refer to the pressure module documentation
for material compatibility.