All material © 2010 Martin Audio Ltd. Subject to change without notice 2
3.10.2 Common settings ................................................................................... 25
3.10.2.1 Source selection ..................................................................................... 25
3.10.2.2 Main delay ............................................................................................... 25
3.10.2.3 AES3 ........................................................................................................ 25
3.10.2.3.1 Gain trim .................................................................................................. 25
3.10.2.3.2 If no link ................................................................................................... 25
3.10.2.4 Sound velocity ........................................................................................ 26
3.10.3 CH1, CH2, CH1+2 Settings ..................................................................... 26
3.10.3.1 EQ ............................................................................................................ 26
3.10.3.2 Q/Bandwidth, Q/Gain and shelving slope dual mode input ................ 26
3.10.3.3 Low-pass and high-pass filters ............................................................. 27
3.10.3.4 Polarity .................................................................................................... 27
3.10.3.5 Channel delay ......................................................................................... 27
3.10.3.6 Gain ......................................................................................................... 28
3.10.3.7 Peak Limiter ............................................................................................ 28
3.10.3.9 Advanced ................................................................................................ 29
3.10.3.9.1 Damping Control .................................................................................... 29
3.10.3.9.2 Filters Definition ..................................................................................... 30
3.10.4 Channel Settings Copy .......................................................................... 30
3.11 How to Setup a crossover ..................................................................... 30
3.12 Setup a bridged configuration ............................................................... 32
3.2 MA Control Manager Overview.............................................................. 32
4.1 Turn-On/Turn-Off muting ....................................................................... 35
4.2 Short circuit protection .......................................................................... 35
4.3 Thermal protection ................................................................................. 35
4.4 DC fault protection ................................................................................. 35
4.5 Input/Output protection ......................................................................... 35
5 Maintenance ......................................................................................... 36
5.1 Cleaning .................................................................................................. 36
5.2 Service ..................................................................................................... 36
5.3 Dust removal ........................................................................................... 36
6
Warranty ............................................................................................... 37
7
Technical notes .................................................................................... 38
7.1 Block diagram ......................................................................................... 38
7.2 Thermal Dissipation ............................................................................... 39
7.3 Specification ........................................................................................... 40
7.4 Technical Drawing .................................................................................. 41