Martin Engineering M3796-05/12 8 EVO
®
Return Roller
Weekly Maintenance
Weekly Maintenance
Read entire section before beginning work.
Maintenance inspection should be performed no less than
weekly. Some applications may require more frequent
maintenance inspections.
Before installing, servicing, or adjusting the conveyor
equipment, turn off and lock out/tag out all energy sources to
the conveyor and conveyor accessories according to ANSI
standards. Failure to do so could result in serious injury or
death.
1. Remove any material from return roller.
2. Make sure all fasteners are tight. Tighten if necessary.
3. Lubricate pivot bearings as necessary.
4. Wipe all labels clean. If labels are not readable, contact Martin
Engineering or a representative for replacements.
5. Remove equipment from service if there is any indication it is not
functioning properly. Call Martin Engineering or a representative for
assistance. Do NOT return equipment to operation until the cause of the
problem has been identified and corrected.
Failure to remove tools from maintenance area and conveyor
belt before turning on energy source can cause serious injury
to personnel and damage to belt.
6. Remove all tools from maintenance area.
Do not touch or go near conveyor belt or conveyor accessories
when conveyor belt is running. Body or clothing can get
caught and pull body into conveyor belt, causing severe injury
or death.
7. Start conveyor belt.
To Next Page
Loading...
General