Martin EVO - Page 15

Martin Engineering M3796-05/12 11 EVO
®
Return Roller
Part Numbers
**XX indicates belt width in inches.
Figure 1. EVO
®
Return Roller, P/N UCRR-007000-XXX (Sheet 2 of 2)
Item Description Part No. Qty
1 Pivoting Weldment UCRR-007030-XX** 1
2 Telescoping Tube Weldment Table I 2
3 Bearing Roller 38505-01 2
4 Rotation Weldment UCRR-007020-XX** 1
5 Sliding Weldment UCRR-007010-XX** 1
6 Roll RR-D6-XX** 1
7 Extended Length Grease Fitting 1/8 NPT 38517 1
8 Plug 3 x 3 37302 1
9 Plug 3 x 3 with Hole 37302-2 1
10 Locking Kit Table I 1
11 Pin Cotter 1/8 x 1-3/4 ZP 14210 1
12 Cap Dust 38515-S 1
13 Washer Flat O.D. 1.75 I.D. 1.015 38513 1
14 Seal Bearing 38516-S 1
15 Nut Hex Slotted 38514 1
16 Screw HHC 1/2-13NC x 1 ZP 13842 4
17 Pin Snap Lock 3/8 x 1-3/4 ZP 37126 1
18 Washer Flat 1/4 Wide ZP 15073 2
19 Tie Tab TMI-TT-100P 2
20 Clip Cable 28112 2
21 Screw Tapping HWH 1/4-20NC x 3/8 ZP 38608 2
22 Cable 1/16 Galvanized 102249 2
23 (NS) Label Kit UCRR-007070 1
24 (NS) Hardware Kit Table I 1
25 (NS) Operator’s Manual M3796 1