8 © 2013 Martin Professional A/S
Martin M6 Safety and Installation Guide
Power Connections
The Martin M6™ accepts AC mains power at 100-240V 50/60Hz. Do not connect it to power
outside this range. Damage resulting from incorrect connection is not covered under warranty.
Only use a Neutrik Powercon NAC3FCA cable connector for power input.
Install only a mains plug that meets local and national electrical codes and is suitable for the
country's specific power outlet types. Refer to a certified electrician for any questions regarding a
country's specific requirements.
A 3-prong grounding-type (earthed type) plug must be installed following the plug manufacturer’s
instructions. The table below shows some possible pin identification schemes; if the pins are not
clearly identified, or if you have any doubts about proper installation, consult a qualified electrician.
Wire color (standard EU code)
1. Check that the power switch is set to the OFF position before connecting the cable.
2. Turn on the desk by toggling the power switch on the front to the ON position.
To Next Page
Loading...
Need help?
General
