© Martin Engineering GmbH 4 M3625UK-10/15
Introduction
The products from Martin Engineering are designed for a long ser-
vice life. They conform to the respective current state-of-the-art sci-
ence and technology and they have been thoroughly tested prior to
delivery. In addition to continuous advanced development of prod-
ucts, Martin Engineering also conducts constant product and market
analyses.
In the event of faults and/or technical problems Martin Engineering
offers professional support. Appropriate steps will be taken immedi-
ately. Martin Engineering's warranty conditions apply, which can be
sent if required.
2.1.4 Reference to additional documentation
The following standards and directives were applied when compos-
ing this installation manual:
• EU Machinery Directive (2006/42/EC)
• ISO/IEC Guide 37 "Installation instructions for end-
consumer used products“, edition 1995
• DIN 1421 "Structure and numbering in texts", edition 1983-
01
• DIN/EN 12100 "Safety of machinery - Basic concepts,
general principles of design", edition 2013-08
• DIN / ISO 16016 "Technical product documentation -
Protection notices for restricting the use of documents and
products", edition 2007-12
• DIN/EN 60204-1 "Safety of machinery - Electrical
equipment of machines, Part 1, General requirements",
edition 2007-06
• DIN EN 82079-1 Preparation of instructions for use -
Structuring, content and presentation - Part 1: General
principles and detailed requirements.
To Next Page
Loading...