What to do if my Martin Industrial Equipment tracker moves unusually?
If your Martin Industrial Equipment tracker moves unusually or not at all, inspect the bearings and its installation position. If needed, correct the installation position according to the manual. Replace any defective bearings.
Why is there greater wear and tear on the rollers in my Martin Industrial Equipment tracker?
If the trough rollers or return rollers in your Martin Industrial Equipment tracker are experiencing greater wear and tear, it might be installed too high in the conveyor system. Check the installation dimensions for the lower unit. Reposition or align it if necessary. For the upper unit, using conveyor belt rollers with less diameter or reinstalling them at another position may help.
How to prevent high wear on Martin Industrial Equipment sensor rollers?
If you observe high wear and tear on the sensor rollers of your Martin Industrial Equipment, check their positioning. They should be installed about 6 mm away from the edge of the conveyor belt, not too close to it and not constantly touching it.
Provides essential safety instructions for working on the product and conveyor belt systems.
Provides critical safety warnings and precautions before commencing installation work.
Covers safety instructions and notes for performing maintenance on the system.
Outlines safety instructions to be followed before commencing troubleshooting activities.
General| Brand | Martin |
|---|---|
| Model | Tracker Series |
| Category | Industrial Equipment |
| Language | English |
To Next Page