MartinLogan 10 - Specifications

8
sPeCiFiCAtions*
Frequency.Response        
Dispersion.              
Sensitivity               
Impedance               
Crossover.Frequency       
High.Frequency.Driver.      
Mid.Frequency.Driver       
Low.Frequency.Drivers.     
Cabinet.                 
Components              
Recommended.Amp.Power   
Binding.Post.Inputs         
Weight                 
Dimensions.(HxWxD).      
MARTINLOGAN.MOTION.10
.65–25,000 Hz ± 3 dB
80° x 80°
90 dB @ 2.83 volts/ meter
4 Ohms. Compatible with 4, 6
or 8 Ohm rated amplifiers.
3,000 Hz
1” x 1.4” (2.6cm x 3.6cm)
Folded Motion Transducer with
5.25” x 1.75” (13.3cm x
4.4cm) diaphragm.
. . . . . . . . . . . . . . . . . . . . .
Two 5.25” (13.3cm) paper
cone with cast aluminum basket.
Non-resonant asymmetrical
chamber format.
Ported
Custom air core coil and low DCR
steel laminate inductors. Polyester
film capacitors in series and low DF
electrolytic capacitors in parallel.
Tweeter thermal/current protection.
20–200 watts
Push style with banana jacks
22 lbs. (10 kg)
35.1” x 9.9” x 10”
(89.1cm x 25.1cm x 25.4cm)
MARTINLOGAN.MOTION.12
.40–25,000 Hz ± 3 dB
80° x 80°
92 dB @ 2.83 volts/ meter
4 Ohms. Compatible with 4, 6
or 8 Ohm rated amplifiers.
300 & 3,000 Hz
1” x 1.4” (2.6cm x 3.6cm)
Folded Motion Transducer with
5.25” x 1.75” (13.3cm x
4.4cm) diaphragm.
5.25” (13.3cm) paper cone
with cast aluminum basket.
Open back dipole.
Two 6.5” (16.5cm) paper cone
with cast aluminum basket. Non-
resonant asymmetrical chamber
format.
Ported with dipole mid-range.
Custom air core coil and low DCR
steel laminate inductors. Polyester
film capacitors in series and low DF
electrolytic capacitors in parallel.
Tweeter thermal/current protection.
20–300 watts
Push style with banana jacks
36 lbs. (16.3 kg)
42.8” x 7” x 14.1”
(108.7cm x 17.8cm x 35.8cm)
*Specifications are subject to change without notice.