Maserati GRANTURISMO MC - Maintenance Procedures for Engine

MASERATI GRANTURISMO MC TROFEO/GT4 SERVICE MANUAL
10
Ver 1.0 2/16
Electronic devices
o Engine ECU: Bosch Motronic ME 7.1.1.
o Gearbox ECU: Magneti Marelli CFC 301.
o Electronic gear box shifting control with two manual paddles at the wheel (gear up
by right paddle, gear down by left paddle).
o Control dashboard with already programmed alarms available.
o Shift lights in top position directly incorporated into the dashboard case.
6.2. Maintenance procedures
6.2.1. First engine start up procedure
Follow this procedure if you are doing the first start of the day, after an engine or gearbox
change, or after a maintenance work on cooling system or oil system.
1. First follow the 6.2.2 Oil level check procedure.
2. Be sure that the engine has got enough water and that there’s fuel in the tank.
3. Connect a jump battery.
4. Turn on the car “MAIN” switch.
5. Wait 2 sec.
6. Turn on ignition switch
7. Push firmly the Start button until the Engine starts.
8. Pay attention, only after a complete pump out of fuel tank, if you want to run the
engine (after refill of fuel) repeat twice time the procedure at point 6), because at
first time the engine will not run.
6.2.2. Oil level check procedure
In order to have the exact check of the oil level, it’s recommended the use of the specific
tool shown in Picture 1. The procedure is the following:
o Condition of the test:
- Cool engine (15°< Water temperature <35°)
- Wait at least 30 minutes since the switch off of the engine.
- Car fixed and parked on an even surface on his 4 tires.
Picture 1. Hollow cylinder.