8
210
Windshield wiper
Windshield wiper
Clean the rubber parts regularly using
the appropriate products.
Change the blades if the edge of the
rubber is deformed or worn. In any
case, the blades should be changed
about once a year.
Travelling with worn wiper
blades is very dangerous
because it reduces the
visibility in the event of poor
atmospheric conditions.
The arms of the wiper blade
have to be replaced with new
ones after two disassembling
operations. The special arm fixing
system guarantees the perfect
mechanical stability only after the first
two refitting operations, provided
that the specified tightening torque is
observed.
It is therefore recommended
to contact the Maserati
Service Network for any
intervention involving wiper arm
disassembling (e.g. replacement of the
dust/pollen filter).
Some simple measures may reduce the
possibility of damage to the blades.
– In the event of temperatures below
zero, make sure that ice has not
glued the wiper to the windshield. If
necessary, release with an anti-ice
product.
– Remove any snow deposited on the
windshield: as well as protecting the
blades, this avoids forcing and
overheating the electric motor.
– Do not activate windshield wiper
when the windshield is dry.
Spray nozzles
If the jet does not work, first check that
there is fluid in the pan (see "Level
checks" in this chapter) then check that
the nozzles are not clogged.
Replacing the wiper blades
1) Raise the arm of the wiper blade
slightly.
2) Push the blade as shown by arrow A
to release it from the arm and then
withdraw the blade.
3) Fit the new blade and secure it in the
seat of the arm as shown by arrow B.
B
A
To Next Page
Loading...
