Mash Fifty 50 CC - Adjustment of Accelerator Wire; Adjustment of Carburetor Idle Speed RPM

52
Adjustment of carburetor idle speed RPM
1. Start the engine and allow it to fully warmed-up without load.
2. Close the accelerator. Rotate the idle adjusting screw to keep the engine
running at 1.400 ± 100 rpm.
Adjustment of accelerator wire
1. Locking nut 2. Adjuster
1. Loosen the locking nut.
2. Rotate the adjuster to make the wire clearance between 0.5 - 1.0 mm.
3. After clearance adjustment, tighten the locking nut once again.
Warning
Idle speed adjustment shall be carried out while the engine is fully warmed
up.