MASSEY FERGUSON 430 - Maintenance Chart

Maintenance and Adjustment
58
410/420/430 - 001 8903 U1
UZEL
Maintenance Chart
Grease all grease nipples, (see page 62) for positions
Check the engine oil level and top up if necessary.
Change the engine oil and filter.
Check valve tip clearances
Drain the sediment from the fuel filter bowl.
Change the fuel filter element.
Check and clean the dry air cleaner MAIN element.
Change the dry air cleaner MAIN element.
Change the INNER SAFETY ELEMENT every 1000 hours.
Check the radiator coolant level and top up if necessary.
Clean the radiator fins.
Drain, flush and refill the cooling system.
Check battery condition and smear terminals with petroleum jelly.
Drain, flush and refill the cooling system.
Check the tension of the alternator/fan belt.
Check the front wheel hub adjustment (two-wheel drive).
Check the front wheel alignment.
Check the transmission/hydraulic oil level and top up if necessary.
Change the transmission/hydraulic oil.
Clean the hydraulic linkage pump oil strainer.
Check the differential lock pedal clearance.
Check the clutch pedal free travel and adjust if necessary.
Check and adjust the live PTO clutch.
Check the brakes and adjust if necessary.
Check all tire pressures.
Check wheel nut tightness.
GREASE POINTS
ENGINE
FUEL SYSTEM
AIR CLEANER
COOLING
SYSTEM
ELECTRICAL
SYSTEM
STEERING
TRANSMISSION
AND
HYDRAULICS
CLUTCH
BRAKES
WHEELS
AND
TIRES
ITEM
Flex
**
100
hours
250
hours
500
hours
1000
hours
1
2
3
4 - Every 1500 hours - Dealer
5
6
9
10
11
12
13
14
15
16
18
19
20
21
22
23
24
25
26
27
28
Symbols and numbers cross refer to the tractor maintenance and lubrication chart, see page 59 for location
purposes.
NOTE: ** Flexible maintenance times vary according to individual conditions of operation. You must establish
times for servicing flexible items. An average interval time for checking these items is at each fuel fill.
Table 5