Massey Ferguson 6400 - Issue 4.a
2B21.10
Splitting the Sisu engine/GTA1030
C . Reassembly
29. Clean the mating faces of the engine and the
gearbox spacer.
30. Check the presence of locating pins on the
gearbox spacer.
N
OTA: During assembly, these pins fit into the drill
holes (1) on the engine adapter plate (Fig. 12).
31. Lightly smear the splines of mainshaft (1) (Fig. 13)
with AS767 graphite grease or equivalent.
32. Grease the mating face of the spacer with
Loctite 5206 or equivalent.
33. Screw two diametrically opposed guide studs on
to the spacer.
34. Assemble the engine onto the gearbox spacer.
If necessary, manually turn the flywheel ring gear
using the port provided to fit the starter, using a
suitable locally made tool. This eases the engage-
ment of the vibration damper splines with those of
the gearbox mainshaft. If there is resistance, do
not force it and find the cause of the problem.
35. Once the engine and gearbox are assembled,
remove the guide studs.
Lightly smear the thread of the screws (1) (2) with
Loctite 270 or equivalent.
Fit the screws and nuts as marked during removal
(Fig. 10). Tighten them to a torque of:
- screws (1): 240 - 320 Nm;
- screws (2): 630 - 840 Nm;
- nuts (3) with washers: 630 - 840 Nm.
1
MA-02-05135A
Fig. 12
Fig. 13
To Next Page
Loading...