MASSEY FERGUSON MF 135 - Lock-Out and Variable Drop Cartridge (Accessory); Attaching and Detaching Implements

rpm, from the Advanced Ferguson Hydraulic
System pump. A single-acting remote cyl-
inder may be operated with the Draft Control
Lever, with the Inner Quadrant Control
lever in the constant pumping position with-
out an Auxiliary Control Valve (Accessory).
To operate one or two double-acting remote
cylinders an Auxiliary Control Valve (Ac-
cessory) must be mounted.
For a complete coverage of the Auxiliary
Hydraulic System ~ refer to the Operator's
Manual of the Auxiliary Hydraulic System,
that accompanies the Tractor.
Lock-Out and Variable Drop Cartridge
(Accessory)
When operating remote cylinders to
raise or lower implements, the rate of cyl-
inder retract (implement lowering) may be
adjusted to suit the operating conditions.
Implements may be lowered from transport
slow or fast, depending upon the adjustment
of the knurled knob located on top of the con-
trol valve body.
To adjust the rate of cylinder retract,
turn the control knob ''out'' to ''slow down''
the retract speed. Turn the control knob
"in" to "speed up" the retract speed.
To hydraulically lock an implement in
transport, turn the knurled knob "out" all
the way. To relieve this hydraulic lock,
turn the knob ''in''.
Fig. 26 - Attaching Left Lower Link to Implement
Fig. 27 - Attaching Right Lower Link to
Implement
ATTACHING AND DETACHING
IMPLEMENTS (See Figs. 26, 27
and 28)
Attaching 3-Point Hitch Implements
The Advanced Ferguson Hydraulic Sys-
tem and 3-point hitch combines your Tractor
and implement into a closely coupled unit,
providing comp 1 et e implement control at
your fingertips.
Attaching and detaching Category I, 3-
point hitch implements is easy and fast. At-
tach and detach implements, as follows:
Fig. 28 - Attaching Top link ·
- 19 -