MASSEY FERGUSON MF 135 - Servicing Procedures

Component Maintenance Required Specifications & Procedures
<$
Each 750 Hours (or Annually) Maintenance
<E?
General
Inspect the complete Tractor
forworn, damaged'or broken
parts.
Power Steering Drain reservoir
and refill
with new oil.
T r a n s m i s s ion, Drain and refill with new oil.
Differential
and
Hydraulic System
Carburetor
(Gas-
Drain fuel and sediment from
oline) bowl, clean and adjust as
necessary.
Front\VheelBear-
Remove, clean and repack.
in gs
Cooling System
Drain, clean
and refill.
Check hoses and clamps for
leaks and condition.
Front Wheel
Check and adjust front wheel
Alignment toe-in to 0 to 1/ 4''.
SERVICING
Diesel Fuel System
Cleaning Fuel System
Fuel Filter (See Fig. 53)
Fuel entering the fuel filter passes
through the filter element into the transpar-
ent agglomerator bowl. Solid impurities
are filtered out of the fuel and entrapped
within the filter element .
Various.
Refer to
''Lubricants
and
Lubrication'' Section
for
type of oil. See pages 33
&52.
Use
Massey-Ferguson
M-
1129-A
Oil only.
See Page
33 and 53.
Refer to ''Servicing'' sec-
tion.
See page 40.
Refer to ''Servicing' '
Sec-
tion. See page 51.
Refer to ''Servicing'' Sec-
tion.
See page 47.
Refer to "Servicing" Sec-
tion.
See page 50.
Fig. 53 - Fuel Filter Diesel
.£Inspect the agglomerator daily. If wa-
ter is present, loosen the drain cock on the
bottom of the agglomerator and drain. Tight-
en the drain cock; "air-bleed" the fuel sys-
tem.
Replacing the Fuel Filter Element
[€oJ Replace the fuel filter ele-
ment every 500 hours of operation
OR when fuel flow becomes re-
stricted.
Before changing the fuel filter element,
THOROUGHLY clean off the outside of the
filter case. Use a genuine Massey-Fer-
guson fuel filter element for best results.
To replace the fuel filter element:
- 38 -