MASSEY FERGUSON MF 135 - Page 46

l
Component
Maintenance Required Specifications & Procedures
e
Each 100 Hour Maintenance
e
Engine Crankcase
Drain oil and refill with new Refer to ''Lubricants and
Oil
oil.
Lubrication' '
Section
for
type of oil.
See page 33.
Clutch Travel
Check free travel and adjust Refer to
''Servicing'' Sec-
as neces sary.
ti on for procedures. See
page 49.
Distributor
(Gas- Check points,
adjust timing Refer to
''Serv icing''
Sec-
oline)
and lubricate.
ti on
for procedures. See
page 41.
Spark Plugs (Gas-
Remove, clean and regap and
Refer to ''Servicing'' Sec-
replace as necessary.
(Re-
tion.
See page 41.
place every 300 hours. )
(
200)
Each 200 Hour Maintenance
~
Hydraulic
Rock-
Lubricate fitting with 1 to 3 Use
lithium base general
shaft
shots of grease.
(Do not
purpose grease. See page
over grease. )
32.
A 1 tern at or Fan
Check tightne ss and adjust
Refer to ''Servicing'' Sec-
Belt
as necessary. tion.
See page 46.
Brakes
Check adjustment
and
Refer to ''Servicing'' Sec-
i
car-
rect as necessary.
tion.
See page 50.
Engine Oil Filter
Replace oil filter.
See page 33.
Air Filter Remove, clean and reinstall
Refer to ''Servicing''
Sec-
or replace.
ti on for procedures.
See
page 42.
r50o,
L-:..1
Each 500 Hours Maintenance
r50o,
L.:-:..1
Valve Tappet
Adjust valve tappet clearance
Refer to ''Servicing'' Sec-
Clearance
to:
tion.
See page 53.
Intake . 012 Clearance (hot)
Exhaust. 015 Clearance (hot)
Fuel
Filter (Die-
Replace filter element. (Air-
Refer to
''Servicing''
Sec-
sel)
Bleed'' the fuel system. )
ti on
for procedures.
See
page 38.
- 37 -