MASSEY FERGUSON MF 135 - Page 45

Component
Maintenance Required Specifications & Procedures
At 2 and 10 Hours of Operating when New and Following Any Front
Wheel Installation
Front Wheel Hub Check the loading of front Tighten
to
155-170 ft. -
Nuts
hub nuts.
lbs. torque.
Daily for First 14 Days Operation-Maintenance
Power Steering Check
reservoir
oil
level, Refer to
''Servicing''
Sec-
and fill as necessary. ti on for procedures. See
i
page 52.
B
Each 50 Hours or Break- In Maintenance
B
Engine Crankcase Drain
"break-in''
oil and
Refer to
''Lubricant
and
Oil and Filter
change
filter.
Refill with Lubrication''
Section for
(First 50 Hours
new
oil of
recommended
type of oil. See page 33.
Only) type.
Transmission, Drain "break-in" oil and re-
Use only Massey-Ferguson
Differential and
fill with new oil.
M-1129-A
Hydraulic
Oil.
Hydraulic System
See Pages 33 and 53.
(First
50 Hours
Only)
Battery
Check level
of
electrolyte --Refer to ''Servicing'' Sec-
and fill as necessary. Elec-
tion.
See page 45.
trolyte level should be main-
tained to the bottom of each
of the filler tubes.
Power Steering Check
reservoir
and
refill
Refer to
''Servicing'' Sec -
as necessary.
ti on and remove air from
system. Ref er to '' Lubri -
cant and Lubrication"
Section for type of oil. See
pages 33 and 52.
Cylinder Head
Torque Cylinder Head Nuts Refer to "Servicing" Sec-
Nuts and Valve to 55-60 ft.-lbs. torque and
ti on
for
tightening se-
Tappet Clearance adj. valve tappet clearance
quence.
See page 53.
(First
50 hours to:
only)
Intake . 012 Clearance (hot)
Exhaust. 015 Clearance (hot)
- 36 -