Need help?Do you have a question about the Massive Audio D 8000 and is the answer not in the manual?
General| RMS Power at 1 Ohm | 8000W |
|---|---|
| RMS Power at 2 Ohms | 4000W |
| RMS Power at 4 Ohms | 2000W |
| Minimum Impedance Unbridged | 1 Ohm |
| THD at Rated RMS Power | <0.1% |
| Signal to Noise Ratio | >90dB |
| Damping Factor | >200 |
| Subsonic Filter | 10Hz - 50Hz |
| LPF Filter | 35Hz - 250Hz |
| Phase Shift | 0-180° |
Proper connection of speaker cables to the amplifier to prevent damage and ensure correct operation.
Instructions for connecting the positive 12V power cable with a fuse to the battery terminal.
Connecting the remote cable to the automatic antenna terminal for amplifier power control.
Guidance on securely connecting the chassis ground cable to a conductive surface.
How to set the gain control to match source unit output without causing distortion.
Using the optional control to adjust subwoofer levels from the driver's seat.
Connecting the amplifier's RCA inputs to the source unit's RCA outputs.
Connecting a signal to another amplifier for bridged configuration.
Sending a bridge signal to a slave amplifier for bridged configuration.
Filtering high frequencies from 40Hz to 220Hz to match woofer response.
Filtering unwanted low frequencies from 10Hz to 50Hz to improve power handling.
Adjusting the boosted center frequency between 30Hz and 80Hz for system matching.
Controlling the boost level for the bassboost center frequency.
Adjusting the curve of the bassboost for optimized bass response.
Switch to control clip limit, reducing distortion at clipping point.
LED indicates clipping or overheating; reduces output power to protect components.
Indicates if the amplifier is in protection mode or experiencing a malfunction.
Shows when the amplifier is switched on; flashes on malfunction.
To Next Page
