Need help?Do you have a question about the Massive Audio E2 and is the answer not in the manual?
Diagram showing the control panel for mono amplifiers.
Diagram showing the control panel for 4-channel amplifiers.
Diagram of the control panel for 2-channel amplifiers.
Diagram illustrating the control panel for 5-channel amplifiers.
Guide for wiring mono amplifiers to a single woofer load.
Guide for wiring mono amplifiers to multiple woofer loads.
Instructions for wiring the EX2 amplifier in a 1-channel configuration.
Instructions for wiring the EX2 amplifier in a 2-channel configuration.
Guide for wiring EX44, EX46, or EX48 amplifiers in 3-channel mode.
Guide for wiring EX44, EX46, or EX48 amplifiers in 4-channel mode.
Instructions for wiring the EX5 amplifier in a 5-channel configuration.
Instructions for wiring the EX5 amplifier in a 3-channel configuration.
General| Channels | 2 |
|---|---|
| Minimum Impedance Unbridged | 2 Ohms |
| Minimum Impedance Bridged | 4 Ohms |
| Signal to Noise Ratio | >95 dB |
| Bass Boost | 0-12dB |
| Bass Boost Frequency | 45Hz |
| Frequency Response | 20Hz - 20kHz |
| Low Pass Crossover Frequency | 50Hz-250Hz |
| High Pass Crossover Frequency | 50Hz-250Hz |
| Input Sensitivity | 0.2V-6V |
To Next Page
