28
29
4.16 Measuring Temperature
To avoid electrical shock, do not connect the
thermocouples with the electriferous circuit.
WARNING
4.16.1 Set the transform switch at the TEMP range
position.
4.16.2 range or range can be transformed by
putting the 'FUNC.'.
4.16.3 The LCD display will show the current
environment temperature.
4.16.4 When measuring the temperature with
thermocouple, 'K' type probe for this meter can
be used. Insert the black plug to the COM jack
and the red one to the INPUT jack, touch the end
of the temperature sensor to the area or surface
of the object for measurement.
4.16.5 You can get reading from LCD.
˚C ˚F
Note:
• With better hermetization, the meter's temperature
measured circuit and environment need a little longer
time to reach heat balance, and then accurate
reading can be gotten.
To Next Page
Loading...
Need help?
General
