36
5. Maintenance
5.2 Fuse Replacement
5.2.1 Fuse rarely need replacement and blow almost
always as a result of the operator's error.
5.2.2 Loosen the fixing screw of the battery cover
and remove it.
5.2.3 Replace the blown fuse with ratings specified.
5.2.4 Put the battery cover as its origin.
6. Accessories
(1) Test Leads: Electric Ratings 600V 10A one piece
Battery:1.5V, AAA three pieces
Operating Manual
(2)
(3) one piece
(4) Thermocouple (K type) one piece
(4) Multifunction test socket one piece
R-00-05-2080
Replace test leads if leads become damaged or worn.
Use meet EN 61010-031 standard, rated CAT III 600V,
MAX 10A or better test leads.
WARNING
5.3 Replacing Test Leads
5.1 Replacing The Batteries
WARNING
To avoid electric shock, make sure that the test
leads have been clearly move away from the
circuit under measurement before opening the
battery cover of the meter.
5.1.1 If the sign “ ” appears, it means that the
batteries should be replaced.
5.1.2 Loosen the fixing screw of the battery cover and
remove it.
5.1.3 Replace the exhausted batteries with new ones.
5.1.4 Put the battery cover back and fix it again to its
origin form.
Note:
Do not reverse the polarity of the batteries.
WARNING
Do not mix old and new batteries. Do not mix
alkaline, standard (carbon-zinc), or rechargeable
(ni-cad, ni-mh, etc) batteries.
To Previous Page
Loading...
