Mastech MS8233E - Cleaning and Decontamination; Specified by the Manufacturer

6-3. Test lead replacement
The test lead has been used and replaced shall be comply with the requirements
specified by the manufacturer in order to ensure operation safety,(1000v CATII or
600V CAT III 10 A or better)
warning TO AVOID ELECTRICAL SHOCK, REMOVE TEST LEADS BEFORE OPENING
BATTERY COVER.
RISQUE DE CHOC ÉLECTRIQUE, RETIRER CORDONS DE MESURE D'OUVERTURE AVANT
couvercle des piles.
6-4.Cleaning and Decontamination
The meter can be cleaned with soft clean cloth to remove any oil, grease or
grim.
Do not use liquid solvent or detergent.
- 17 -