Note:
• If the input open circuit (or the circuit resistance
measured is higher than 200Ω), then the figure '0L'
will be displayed.
5. Maintenance
5.1 Battery Replacement
6. Accessories
(1) Test Leads: Electric Ratings 1000V 10A one piece
(2) Battery: 1.5V, AAA two pieces
one piece(3) Operating Manual
19
5.2 Replace the Probe
R-00-05-0873
Before attempting open the battery cover or case of
the meter, be sure that test leads have been
disconnected from measurement circuit to avoid
electric shock hazard.
WARNING
WARNING
To avoid electric shock, make sure that the test
leads have been clearly move away from the
circuit under measurement before opening the
battery cover of the meter.
WARNING
Do not mix old and new batteries. Do not mix
alkaline, standard (carbon-zinc), or rechargeable
(ni-cad, ni-mh, etc) batteries.
If the sign “ ” appears, it means that the batteries
should be replaced.
Loosen the fixing screw of the battery cover and remove it.
Replace the exhausted batteries with new ones.
Put the battery cover back and fix it again to its origin form.
Note:
Do not reverse the polarity of the batteries.
If insulation on probe is damaged, replace it.
WARNING
Use meet EN 61010-031 standard, rated CAT III 600V, 10A or
better probe.
To Previous Page
Loading...
Need help?
General
