Master & Dynamic MW07 GO User Manual

High Med
Low
EARPHONE BATTERY
CASE BATTERY
4
BATTERY INDICATORS
The charging case holds an additional 12 hours of charge for your earphones. We
suggest you place your earphones inside the case when they are not in use. This
will allow them to have the maximum charge each time you begin to use them.
When you place the earphones inside the case and close the lid, the earphones
and case battery status will display. A green light indicates the battery is
between 70-100%, amber indicates 30-69%, and red indicates 1-29%. If the
center battery flashes red or does not display, the case battery is depleted.
To charge your case, plug the USB-C cable into the back of your case and plug
the other end into a power source. If you do not have a USB-C power source you
can use our supplied USB-C to USB-A adapter to use a USB-A power source.
The battery status of the case and earphones will remain visible while the
case charges.
Case and earphones recharge to 50% in 15 min, 100% in 40 minutes

Master & Dynamic MW07 GO Specifications

General

Headset type	Binaural
Product type	Headset
Product color	Black, Grey
Wearing style	In-ear
Recommended usage	Calls/Music
Protection features	Water resistant
International Protection (IP) code	IPX6
Bluetooth	Yes
Wireless range	30 m
3.5 mm connector	No
Bluetooth version	5.0
Connectivity technology	Wireless
Impedance	- Ω
Driver unit	10 mm
Magnet type	Beryllium
Ear coupling	Intraaural
Headphone frequency	- Hz
Microphone type	Built-in
Battery type	Built-in battery
Charging source	USB
Battery recharge time	0.4 h
Continuous audio playback time	22 h
Quantity	1
Charging case type	Wired
Charging case connector type	USB Type-C

Weight and Dimensions

Depth	18 mm
Width	21 mm
Height	25 mm
Weight	7.4 g
Charging case weight	76 g
Charging case dimensions (W x D x H)	64 x 40 x 28 mm