1 - GENERAL FEATURES
Our amplifiers are modular in design. The metal chassis is very rigid and the interior
design provides easy access to the electronic circuits.
Fully independent safety circuits protect the amplifier in the event of a short circuit of
the loudspeaker output, abnormal increases in temperature and/or excessive
amplifier consumption.
These amplifiers offer high performance and damping factor, which results in clean
response to transients and high quality playback. The heat sinks, of our own design,
combine high heat dissipation with a reduced weight and thermal inertia.
2 - FRONT PANEL FEATURES
- On-Off switch (7)
- Volume potentiometers (Gain)(2)
- Output Signal indicators (-20dB, -10dB)(3)
- Independent Indicators of Peak Limiter (4), and Protection (5)
- Bridge mode (1) and Parallel mode (6) indicators
3 - REAR PANEL FEATURES
- Forced ventilation turbine (1)
- 230V power supply (2)
- Loudspeaker output connection. Speakon (3) and Terminals (4)
- LEDs monitoring connection (5) (Allow monitoring of the amplifier’s limiter, when it is
far away)
- Mode Selection Switches. Stereo (6), Bridge (7) and Parallel (6)
To Next Page
Loading...