3/20 Rev. A 57-02699
3
INTRODUCTION
Thank you for purchasing a Master-Bilt
®
cabinet. This manual contains important instructions for installing, using, and servicing a
Master-Bilt
®
IHC case. A parts list is included with this manual. Read all these documents carefully before installing or servicing
your equipment.
STORE CONDITIONS
The Master-Bilt
®
IHCcases are designed to operate in the controlled environment of an air-conditioned store. The store
temperature should be at or below 75°F and a relative humidity of 55% or less. At higher temperature or humidity conditions, the
performance of these cases may be affected and the capacity diminished.
The Master-Bilt
®
IHC should not be positioned where it is directly exposed to rays of sun or near a direct source of radiant heat
or airflow. This will adversely affect the case and will result in poor performance.
If this case is to be located against a wall, there should be at least 4” space between the wall and the back of the case. This
space will allow for the circulation of air behind the case, which will prevent condensation on the exterior surfaces.
NOTICE
Read this manual before installing your cabinet. Keep the manual and refer to it before doing any
service on the equipment. Failure to do so could result in personal injury or damage to the cabinet.
DANGER
Risk of fire or explosion. Flammable refrigerant used. Consult instruction manual/repair
manual/owner’s guide before attempting to install or service this product. All safety precautions
must be followed.
NEVER use an extension cord to power these units. All electrical wiring hook-ups must be done
in accordance with all applicable local, regional or national standards.
DANGER
Improper or faulty hook-up of electrical components on the refrigeration units can result in severe injury or death.
NEVER use an extension cord to power these units. All electrical wiring hook-ups must be done in accordance with all
applicable local, regional or national standards.
NOTICE
Installation and service of the refrigeration and electrical components of the cabinet must be performed by a
refrigeration mechanic and/or a licensed electrician.
The portions of this manual covering refrigeration and electrical components contain technical instructions intended only for
persons qualified to perform refrigeration and electrical work.
This manual cannot cover every installation, use or service situation. If you need additional information, call or write us:
Customer Service Department
Master-Bilt Products
Highway 15 North
New Albany, MS 38652
Phone (800) 684-8988
Fax (866) 882-7629
To Next Page
Loading...
