Page 9
• Miter Cut: A cutting operation made with the work piece
at any angle other than 90° to the blade.
• Compound Cut: A crosscut made with both a miter angle
and a bevel angle.
SAFETY INSTRUCTIONS
• Work Piece Clamp: The work piece clamp is mounted on
the left or right base to securely clamp the work piece.
• Blade Wrench: One end of the blade wrench is a Phillips
screwdriver and the other end is a hex key. It is used for
changing the blade. The storage area for the blade wrench
is located in the left side of the rear carrying handle.
• Bevel Cut: A cutting operation made with the blade at
any angle other than 90° to the table surface.
To Next Page
Loading...