D1000 Features
One Touch Lock
When the deadbolt is retracted, touching any button while awake will extend the latch
Low Power Indication
When battery power is low, some prompts remind you to replace batteries:
1.
The keypad arrow button lights RED.
2. The lock creates an audible beep sound
3. The low battery warning notification
Emergency Power
In case battery power is completely lost, connect a USB power bank to the TYPE-C port on the bottom of the keypad
(not provided).
Invalid Passcode Keypad Lockout
After 3 times unsuccessful attempts at entering a valid PIN code, the keypad will be disabled and display an X pattern
indicating that the lockout is active.
Low Power Protection
The devices will auto launch in low power status:
1.
Bluetooth off
2. Keypad off and no buzzer ring
Jam Detection
If the lock is jammed or not aligned with the door frame, the motor stops to prevent damage to the lock.
High Indoor Temperature Alarm
The lock will beep, the keypad will flash and the door sensor will flash RED when the indoor temperature is over
60°C / 140 °F.
Tamper Alarm
If tampering is detected, an event will be logged in the history and the lock will beep in 1 minute intervals until
tamper sensor is cleared.
To Previous Page
Loading...
