58DO NOT DIVE.
Spa Controls
SYSTEM-RELATED MESSAGES
PROGRAM MEMORY FAILURE*
At Power-Up, the system has failed the Program Checksum Test. This indicates a problem with the
firmware (operation program) and requires a service call.
THE SETTINGS HAVE BEEN RESET (PERSISTENT MEMORY ERROR)*
Contact your dealer or service organization if this message appears on more than one power-up.
THE CLOCK HAS FAILED*
Contact your dealer or service organization.
CONFIGURATION ERROR (SPA WILL NOT START UP)
Contact your dealer or service organization.
A PUMP MAY BE STUCK ON
Water may be overheated. POWER DOWN THE SPA. DO NOT ENTER THE WATER. Contact your
dealer or service organization.
HOT FAULT
A Pump Appears to have been Stuck ON when spa was last powered
POWER DOWN THE SPA. DO NOT ENTER THE WATER. Contact your dealer or service organization.
* This message can be reset from the topside panel.
To Next Page
Loading...
