1
Model Number MP-MCA-30T
Rated Service Flow (gpm) 17.8
Pressure Drop at Rated Service Flow
Rate (psi)
15
Rated Softening Capacity (KGrains) 18.8 @ 4.5 lbs salt
20.0 @ 6.0 lbs salt
28.9 @ 15.0 lbs salt
Efficiency at the 1.0 lb. Salt setting
(Grains/lbs salt)
4186
Min.-Max. Working Pressure (psi) 20 to 100
Min.-Max. Operating Temperature
(°F)
35 to 100
Max. Flow Rate (gpm) to Drain
During Regeneration Cycle
1.7
Amount of High Capacity Resin
(cu ft)
1.0
These softeners conform to NSF/ANSI 44 for the specific performance claims as verified and substantiated by
test data. These models are efficiency rated. The efficiency rating is valid only at the stated salt dose and
maximum service flow rate. They have a demand initiated regeneration (D.I.R.) feature that complies with
specific performance specifications intended to minimize the amount of regenerant brine and water used in their
operation. These softeners have a rated softener efficiency of not less than 3350 grains of total hardness
exchange per pound of salt (based on sodium chloride) and shall not deliver more salt than their listed ratings.
The rated salt efficiency is measured by laboratory tests described in NSF/ANSI Standard 44. These tests
represent the maximum possible efficiency that the systems can achieve. Operational efficiency is the actual
efficiency after the system has been installed. It is typically less than the efficiency due to individual application
factors including water hardness, water usage, and other contaminants that reduce the softener’s capacity. These
systems are not intended for use with water that is microbiologically unsafe or of unknown quality without
adequate disenfection before or after the system. Refer to Installation/operation manual and warranty for further
details on installation, parts and service, maintenance and further restrictions or limitations to the use of the
product.
Master Water Conditioning
224 Shoemaker Rd.
Pottstown, PA 19464
610.323.8358
610.323.5526
www.masterwater.com
Performance Data Sheet
To Next Page
Loading...
