EasyManua.ls Logo

Masterbuilt 20101513 - User Manual

Masterbuilt 20101513
2 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
SMOKER SIDE SHELF
Upright Position
With both hands on the left and right of the shelf, lift
smoker side shelf. When shelf is in full upright position,
push the shelf gently towards the smoker. The hinge will
then drop and lock into place.
Downward Position
Again, with both hands on each side of the smoker side
shelf, slightly lift the shelf to remove it from its locked
position, then gently pull towards yourself and swing the
shelf into its downward position.
FITS MASTERBUILT 30-in. MODELS: 20070411, 20070911, 20071011, 20071111
FITS MASTERBUILT 40-in. MODELS: 20070211, 20070212, 20070311, 20071211,
20071311, 20071411, 20071611, 20071711
POSITIONING
Model# 20101513
Masterbuilt Manufacturing, Inc. · 1 Masterbuilt Ct. Columbus, GA 31907 · Customer Service / Servicio de atención al cliente: 1-800-489-1581 · www.masterbuilt.com
081612-04SS
MADE IN CHINA
C
A
1
Facing right side of smoker, remove door hinge
cover screw (A) and door hinge cover (B), then re-
move only the closest door hinge screws (C) from
hinge. (Do not remove far rear screws as the door
will loosen and the seal could be compromised.)
1
Still facing the right side of smoker, slightly loosen
handle screws (D) and completely remove handle
screws (D) closest to you, allowing rear handle (E)
to move freely.
2
Insert hinge cover screw (A) through door hinge
cover (B), then take nut (F) and thread onto screw
taking care not to fully tighten screw; leaving a
slight gap between the nut (F), door hinge cover
(B) and screw (A).
3
With smoker side shelf (G) in downward position,
align shelf support bracket and holes onto the right
side of smoker body as shown.
With side shelf (G) between smoker body and
handle (E), replace handle screws (D) and door
hinge screws (C). Tighten all screws at this time.
Re-set door hinge cover (B) over door hinge and
secure with door hinge cover screw (A) as shown.
Shelf installation is now complete.
4
2 3
4
E
E
G
C
B
B
CAUTION
· SMOKER SIDE SHELF WEIGHT CAPACITY 25 LBS.
· NEVER MOVE SMOKER WITH SHELF IN UPRIGHT POSITION.
· DO NOT SIT ON OR LEAN AGAINST SHELF.
· WHEN ADJUSTING SHELF, KEEP FINGERS CLEAR OF HINGES.
D
D
A
D
B
A
F

Questions and Answers

  • M
    Mia WilliamsAug 8, 2025
    How to clean a Masterbuilt Grill smoker?
    • D
      Dylan JonesAug 9, 2025
      To clean your Masterbuilt Grill smoker, follow these steps: * For smoking racks, water bowl, and drip tray, use a mild dish detergent. Rinse and dry thoroughly. * Clean the wood chip tray and wood chip loader frequently to remove ash build-up, residue, and dust. * Wipe down the interior, glass in the door, light cover, meat probe, and exterior with a damp cloth. Do not use cleaning agents and dry thoroughly. * Clean the door seal and the inside seam after each use to maintain the seal's condition. * Always ensure the unit is unplugged and cool before cleaning and storing.
  • J
    jamesdominguezAug 13, 2025
    Why does my Masterbuilt Smokers take so long to heat up?
    • S
      Stanley JonesAug 13, 2025
      If your Masterbuilt Smoker is taking longer than 60-70 minutes to heat up, there might be a couple of reasons. Ensure the unit is not plugged into an extension cord. Try to position the unit so that an extension cord isn't needed. Also, make sure the door is completely closed and the latch is securely fastened.
  • V
    Victoria SmithAug 16, 2025
    What to do if the power light won’t come on on Masterbuilt 20101513?
    • J
      Jaime SalazarAug 16, 2025
      If the power light on your Masterbuilt Smoker won't turn on, start by checking the wall connection to ensure it's properly plugged in. Next, verify that a house fuse hasn't tripped, and avoid operating other appliances on the same electrical circuit. If these steps don't resolve the issue, further assistance may be needed.
  • C
    Cassandra WhiteAug 21, 2025
    Why is there no smoke from my Masterbuilt 20101513 Smokers?
    • A
      Amy NguyenAug 21, 2025
      If your Masterbuilt Smoker isn't producing smoke, the most likely cause is a lack of wood chips. Add wood chips to the smoker to generate smoke.
  • N
    newtonstephenAug 26, 2025
    What to do if grease is leaking from my Masterbuilt Smokers?
    • S
      Samuel ShawAug 26, 2025
      If grease leaks from your Masterbuilt Smoker through the door and legs, it could be due to several reasons. First, ensure the drip pan is correctly positioned, aligning its hole with the drain hole at the bottom. Excess grease buildup can also cause leaks, so clean the unit thoroughly. Lastly, check the drain tube at the back of the unit to ensure it's not blocked and is draining properly.
  • C
    Courtney JonesAug 30, 2025
    How to fix interior light that does not come on in Masterbuilt 20101513 Smokers?
    • D
      David AllenAug 30, 2025
      If the interior light of your Masterbuilt Smoker isn't working, first check if the bulb is burned out and replace it with a 15W-25W bulb made for ovens. Also, ensure that the light switch is in the 'on' position.
  • V
    Victor WalkerSep 3, 2025
    Why will remote not control Masterbuilt 20101513?
    • D
      Deborah EatonSep 3, 2025
      If the remote isn't controlling your Masterbuilt Smoker, ensure the batteries aren't weak or installed incorrectly. Refer to page 13 instructions for how to install the batteries.

Masterbuilt 20101513 Specifications

General IconGeneral
BrandMasterbuilt
Model Number20101513
CategorySmokers
TypeElectric Smoker
Temperature Range100°F to 275°F
Power800 watts
MaterialSteel
Digital Control PanelYes
Number of Racks4
Removable Drip PanYes
Wood Chip LoaderYes
Power SourceElectric

Related product manuals