SELECTING PROPER SPEEDS
Different speeds are required depending
upon the type of operation being
performed. The following chart outlines
those basic speeds:
WARNING: Have you read
“GENERAL SAFETY WARNINGS”,
“POWER TOOL SAFETY”,
“SPECIFIC SAFETY RULES”,
“BATTERY AND CHARGER
SAFETY” and “SYMBOLS” on pages
3, 4, 5, 6, 7, 8 & 9 of this Manual? If
not, please read them now before
you operate this rotary tool. Your
safety depends on it!
Every time you use the rotary tool
you should verify the following:
1. The accessory is in good
condition and not damaged in
any way.
2. The workpiece is properly
secured.
3. Safety glasses are being worn.
Failure to adhere to these safety
rules can greatly increase the
chances of injury.
To Next Page
Loading...
Need help?
General
