MasterCraft 054-2500-0 User Manual

11
4V LITHIUM-ION COMPACT SCREWDRIVER - 054-2500-0
OPERATING INSTRUCTIONS
Chargingthebattery(g 2)
The battery charger provided matches the
Lithium-Ion battery installed in the tool. Do
not use any other battery charger.
The Lithium-Ion battery is protected
against deep discharging. When the
battery is fully discharged, the tool is
switched off by a protective circuit.
1. Attach the charger cord to the socket.
2. Plug charger into any 120V~60Hz
outlet. Your tool is now charging; the charging indicator will shine red.
3. The battery is fully charged as soon as the battery charge indicator shines off.
NOTE:This charger can be used only with a 60Hz, 120V AC circuit.
4. When recharging, the tool will require approximately 3–5 hours reaching full capacity. The
tool will not overcharge, and can remain attached to the charger indefinitely while not in use
throughout the cutting session.
Warning!
Avoid charging your screwdriver in freezing conditions. The power unit provided must
only be used with this screwdriver and not with any other products.
Triggerswitch
To turn the Drill ON, depress the trigger switch. To turn it OFF, release the trigger switch.
g 2

MasterCraft 054-2500-0 Specifications

General

Brand	MasterCraft
Model	054-2500-0
Category	Power Screwdriver
Language	English