ROUTER TABLE - 054-6938-6
9
• Before each use, check the router and the table to ensure that all fasteners are still tight.
A loose table is unstable, and may shift during use.
• Unplug the router before installing it into the table.
• Turn off the router-table safety switch that controls power to the router or unplug the
router before making adjustments or changing accessories, such as bits or cutters.
• Always wear a dust mask and ear protection when using this power tool.
• Only use cutters that are designed for the particular router in use.
• Only use sharp cutters that are not chipped or cracked. Blunt cutters will cause stalling.
• Secure small pieces of wood firmly before working. Never hold a workpiece by hand.
• Secure the workpiece using clamping equipment.
• Before starting the router, check that the cutter bit is firmly positioned and secured in the collet.
• Do not exceed the maximum indicated rotation speed of the cutter bit.
• Routing operations must always be performed against the direction of rotation of the
cutter bit (cutter rotation).
• Note that the direction of rotation is reversed when the router is installed in the router
table: when installed in the router table, the cutter rotates counter-clockwise.
• The cutter bit must be running at full speed before it is lowered to the workpiece.
• When operating the router, always hold the handles firmly with both hands. Always ensure
that footing is secure when working.
• Be prepared for the reaction torque of the router, particularly if the cutter bit becomes
jammed in the workpiece.
• Become familiar with the working area, and be alert for possible hazards that cannot be
heard due to the noise of the router.
• Never slow the router down with your hands.
• Do not touch the cutter immediately after operation. It may be extremely hot, and could burn.
• Never stop the router by applying lateral pressure to the cutter.
• Do not force the router. It will do a better job if it is allowed to work at its intended speed.
• Avoid cutting nails and screws. Inspect timber before cutting, and remove all nails and screws.
• In the event of an electrical or mechanical malfunction, switch the router off immediately, and
disconnect the power cord from the outlet.
SAFETY GUIDELINES
To Next Page
Loading...
Need help?
General
