headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
9
SAFETY GUIDELINES
• Secure the workpiece. Clamping devices or a vise will hold the workpiece in place better than
the hand.
• Always wait until the tool has come to a complete stop before placing it down. The tool
insert can jam, which can lead to loss of control.
• Always set the rotational direction switch to centre position before performing
any kind of work on the machine (e.g., maintenance, tool change, etc.) and when
transporting and storing it. Unintentional activation of the On/Off switch may result in personal
injury.
• Wear ear protectors when using the impact driver. Exposure to noise can cause hearing
loss.
• Use protective gloves when removing the bit from the tool, or allow the clamp to cool
down first. The bit may be hot after prolonged use.
• Use protective gloves when operating the tool. Protective gloves can help to keep you from
being burnt and hurt.
• Keep your hands away from the motor housing vents. Hot gas comes from the vents during
operation.
• Release the trigger immediately when the screw is tightened to avoid breaking the
screw.
WARNING!
To reduce the risk of electric shock or damage to the charger and battery, use only the
Mastercraft
®
batteries and chargers listed.
BATTERY PACK CHARGER
054-3124-0, 054-7553-4, 054-7557-6, 054-2434-8 054-3126-6, 054-7559-2
• For best results, your battery tool should be stored and used in a location where the
temperature is more than 5°C (41°F) but less than 40°C (104°F). Do not store outside or
in vehicles.
To Next Page
Loading...
Need help?
General
