headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
9
SAFETY GUIDELINES
• Wear ear protectors when using the drill/driver. Exposure to noise can cause hearing loss.
• Use protective gloves when removing the bit from the tool, or first allow the bit to cool
down. The bit may be hot after prolonged use.
• Use protective gloves when operating the tool. Protective gloves can help to keep you from
being burnt or injured.
• Keep your hands away from the motor-housing vents. Hot gas comes from the vents
during operation.
• Release the trigger immediately when a screw is tightened to avoid breaking the
screw.
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................... Volts
A ..................... Amperes
Hz ................... Hertz
W .................... Watts
min ................. Minutes
................. Alternating current
or d.c. .............. Direct current
n
0
................... No-load speed
............... Class II Construction
…/min ........... Revolutions or reciprocation per minute
............... Grounding terminal
BPM ............... Beats per minute
RPM ............... Revolutions per minute
.............. WARNING – To reduce the risk of injury, user must read instruction manual.
.............. WARNING – To reduce the risk of injury always wear eye protection.
.............. WARNING – To reduce the risk of injury always wear ear protection.
• Protect the battery from heat and fire. There is a risk of explosion.
• Do not open the battery. There is a risk of a short circuit.
• Keep the cord and charger from heat to prevent damage to the housing or internal
parts.
To Next Page
Loading...
Need help?
General
