CORDED MULTI-CRAFTER KIT - 054-8251-6CORDED MULTI-CRAFTER KIT - 054-8251-6
17 18
PROBLEM POSSIBLE CAUSES SOLUTIONS
The motor is overheating Be sure the cooling vents are free
of dust and obstacles
Clean and clear vents. Do not cover
with hand during operation
Iftheproblemremainsunsolvedafterperformingthechecksdescribedabove,callthetoll-
freehelplineat1-800-689-9928.
TROUBLESHOOTING
Before each use
1. Inspect the multi-crafter, the On/Off switch, the cord and the accessories for damage.
2. Check for damaged, missing, or worn parts.
3. Check for loose screws, misalignment or binding of moving parts, or any other condition that may
affect the operation.
4. If abnormal vibration or noise occurs, turn the tool off immediately and have the problem corrected
before further use.
WARNING!
Unplug the tool from power source before cleaning or performing any maintenance. Using
compressed air may be the most effective cleaning method. Always wear safety goggles
when cleaning tools using compressed air.
WARNING!
Do not allow brake fluids, gasoline, petroleum-based products, penetrating oil, etc. come
into contact with plastic parts. These substances contain chemicals that can damage,
weaken, or destroy plastic.
WARNING!
When servicing, use only identical replacement parts. The use of any other parts may
create a hazard or cause damage to the product.
WARNING!
Use only accessories that are recommended for this multi-crafter by the manufacturer.
Accessories that may be suitable for one tool may become hazardous when used with
another tool.
WARNING!
Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools
with sharp cutting edges are less likely to bind, and are easier to control.
WARNING!
To ensure safety and reliability, all repairs should be performed by a qualified service
technician.
MAINTENANCE
To Next Page
Loading...
Need help?
General
