MasterCraft 054-8251-6 User Manual

CORDED MULTI-CRAFTER KIT - 054-8251-6CORDED MULTI-CRAFTER KIT - 054-8251-6
15 16
Selecting the application tool
APPLICATION TOOL MATERIALS QUANTITY APPLICATION
Flush Cut
Blade
Wood, Plastic, dry
wall
1
Flush Cut
Blade
Wood, Plastic,
Drywall, Soft
Metals
1
Flexible
Scraping Blade
Flexible Adhesive
& Caulk
1
Segmented
Saw Blade
Wood, Plastic,
Drywall
1
Sanding Pad
and Sanding
paper
Bare or Painted
Wood, Plaster, and
other surfaces,
depending on
sandpaper grit
1 pad; 5
sheets
sanding
paper
Sanding
WARNING!
Do not touch the gear box after prolonged use; it could be very hot.
Sanding accessories are suitable for the dry sanding of wood, metal, surfaces, corners and edges and
hard to reach areas.
Work with the complete surface of the sanding pad, not only with the tip.
Sand with a continuous motion and light pressure. Do not apply excessive pressure. Excessive pressure
will result in poor handling, vibration, unwanted sanding marks and premature wear on the sanding
sheet.
The following suggestions may be used as a general guide for abrasive selection, but the best results
will be obtained by sanding a test sample of the workpiece first.
GRIT APPLICATION
Coarse For rough wood or metal sanding and rust or old finish removal
Medium For general wood or metal sanding.
Fine For final finishing of wood, metal, plaster and other surfaces
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS

MasterCraft 054-8251-6 Specifications

General

Brand	MasterCraft
Model	054-8251-6
Category	Power Tool
Language	English