model no. 054-8259-0 | contact us 1.800.689.9928
12
THE FOLLOWING CHART CAN HELP YOU PICK THE PROPER SPEED, BLADE
AND ORBIT ACTION
Workpiece to be cut Setting on the speed
dial
Teeth per inch of the
blade
Orbit
Soft wood 5–6 6 Max. orbit
Hard wood 3–4 6 Med. orbit
Mild steel, aluminum 3–6 14–24 No orbit
Stainless steel 3–4 14–24 No orbit
Plastic 1–4 10–12 Min. orbit
SAWDUST REMOVAL
Dust blower
The dust blower helps clear the cutting area of debris
created from the blade.
To turn the dust blower on: slide the dust blower switch
to the “
” position.
To turn the dust blower off: slide the dust blower switch
to the “
” position.
ASSEMBLY INSTRUCTIONS
INSTALLING THE SAW BLADE
(fig 6)
1. Unplug the jigsaw from the power supply.
2. Turn the tool upside down, depress the tool-less
blade clamp, and insert the blade into the slot of the
clamp as far as it can go. The back of the blade must
rest in the groove of the guide roller (fig 7).
3. Release the tool-less blade clamp to lock the blade.
Pull on the blade to check that it is securely locked in
place.
REMOVING THE SAW BLADE
1. Unplug the jigsaw from the power supply.
2. Turn the tool upside down; depress the tool-less
blade clamp to remove the blade.
IMPORTANT INFORMATION
ASSEMBLY INSTRUCTIONS
fig 5
On Off
fig 7
Guide roller
fig 6
CAUTION!
• For all work or when changing the blade, always wear protective gloves. The sharp edge
of the blade will cause personal injury. The blade can be very hot while working.
• Allow the blade to cool after use. The blade can become dangerously hot.
WARNING!
• Check that the blade is correctly attached. An incorrect or insecurely fastened blade can
come loose during operation and cause a hazard.
• Always ensure that the tool is turned OFF and unplugged from the power supply before
making any adjustments and installing any attachments.
To Next Page
Loading...
Need help?
General
