Need help?Do you have a question about the MasterCraft 055-6740-2 and is the answer not in the manual?
General| Model | 055-6740-2 |
|---|---|
| Category | Saw |
| Type | Circular Saw |
| Blade Size | 7-1/4 inches |
| Blade Diameter | 7-1/4 inches |
| Cord Length | 6 feet |
| Depth of Cut at 45 degrees | 1-3/4 inches |
| Amperage | 15 A |
| No Load Speed | 5, 500 RPM |
| Bevel Capacity | 56° |
| Depth of Cut at 90 degrees | 2-7/16 inches |
Read manual, avoid dangerous conditions, keep work area clean, dress for safety, unplug tool, avoid accidental start-ups, maintain tools properly.
Make workshop childproof, do not operate under influence, ensure proper checks and maintenance.
Check assembly, use blade guard, know saw condition, never free hand, keep body out of blade path, ensure water supply, inspect blade, do not leave unattended.
Always wear eye protection, use dust mask, wear ear protection, ensure saw is fully assembled before operation.
Ensure proper grounding, do not alter plug, use 3-wire extension cords with 3-pronged plugs.
Use heavy enough cord, check condition, keep away from hazards, use separate circuit.
Verify outlet grounding, use drip loop, do not operate if wet, ensure proper voltage.
Carefully remove contents, inspect all parts, account for all items before discarding packaging.
Position handle over rail support holes and secure with washer and bolt.
Submerge pump, connect tubing, position pump in tray clips, secure pump bracket.
Remove guard, loosen blade nut, replace blade collar and blade, tighten blade nut.
Insert gauge peg into worktable groove, slide assembly, tighten knob to lock position.
Ensure drain plug is in place, add water to cover metal rack, keep pump submerged.
Turn off saw, unplug, place container, remove drain plug to drain water.
Use ON/OFF switch to operate saw. Press reset button after overload.
Fill water, position tile, align with ruler, secure tile, turn on saw, push blade assembly forward.
Place tile corner in ruler groove, secure tile, follow cutting instructions.
Loosen mitre gauge, set angle, place tile, align with blade, tighten gauge, secure tile.
Place tile, secure it, loosen bevel knobs, tilt blade assembly, tighten knobs.
Use dry silicone spray for lubrication. Inspect all parts before each use for safety.
Empty water tray after use, clean with dry rag, avoid solvents.
Turn off saw, unplug, disconnect pump, loosen knobs, lift blade assembly out.
List of all parts with corresponding numbers, descriptions, and quantities for servicing.
Covers defects in workmanship and materials for 3 years, with exceptions for accessories and normal wear.
Requires proof of purchase, excludes abuse, misuse, accidental damage, neglect, lack of maintenance, or commercial use.
Warranty is non-transferable; excludes indirect damages. Provides specific legal rights per province.
To Next Page