MasterCraft 055-6742-8 - Quick Start Guide; Specifications

• Place the table saw on top of the stand and
align the mounting holes at the base of the
table saw with corresponding holes in the
stand.
• Insert four hex bolts (2) along with flat
washers (3) into the aligned holes and tighten
the bolts.
see page 31
1
• The product can be switched on by
pressing the green “I”-Button on the
on/off switch (1).
• The product can be switched off by
pressing the red “0”-Button on the
on/off switch (1).
see page 51
2
SPECIFICATIONS
Motor
Speed
Blade
Right extension table
Main table size
Rear out-feed support
Rip capacity
Bevel range
Mitre range
Depth of cut at 90°
Depth of cut at 45°
Arbour size
Table height
Weight
120 V AC, 60 Hz, 15A
4500/MIN (no load)
10" (25.4 cm) 40-tooth carbide-tipped
5 1/8 x 23" (13 x 58.5 cm)
23 15/16 x 23" (60.8 x 58.5 cm)
23 15/16 x 2 1/2" (60.8 x 6.5 cm)
24" (61 cm) right; 10" (25.4 cm) left
0-45°
0-60° left & right
3 9/64" (8 cm)
2 5/32" (5.5 cm)
5/8" (1.59 cm)
35" (88.9 cm)
72 lb 11 oz (33 kg)
5
SPECIFICATIONS
4
QUICK START GUIDE
model no. 055-6742-8 | contact us 1-800-689-9928
2
3
1