WARNING! EXPOSURE TO EXCESSIVE NOISE LEVELS CAN RESULT IN PERMANENT
HEARING LOSS. ALWAYS WEAR EAR PROTECTION (SAFETY EAR MUFFS OR EAR
PLUGS) TO REDUCE NOISE LEVELS WHEN OPERATING THE BAND SAW.
13. NEVER LEAVE A RUNNING TOOL UNATTENDED. Turn the power switch to the OFF
position. DO NOT leave tool until it has come to a complete stop.
14. NEVER STAND ON THE TOOL. Serious injury could result if the tool tips or is accidentally
jarred. DO NOT store anything above or near the tool.
15. DO NOT OVERREACH. Keep proper footing and balance at all times. Wear oil-resistant,
rubber-soled footwear. Keep the floor clear of oil, scraps, and other debris.
16. MAINTAIN TOOLS PROPERLY. ALWAYS keep tools clean and in good working order. Follow
instructions for lubricating and changing accessories.
17. CHECK FOR DAMAGED PARTS. Check for alignment of moving parts, jamming, binding,
breakage, improper mounting, or any other conditions that may affect the operation. Any part that
is damaged should be properly repaired or replaced before use.
18. MAKE THE WORKSHOP CHILDPROOF. Use padlocks and master switches, and ALWAYS
remove starter keys.
19. DO NOT operate the tool if you are under the influence of any drugs, alcohol, or medication
that could affect your ability to use the tool properly.
ＩＩ． Ｇｅｎｅｒａｌ ｓａｆｅｔｙ ｇｕｉｄｅｌｉｎｅｓ （ｃｏｎｔｉｎｕｅｄ）
4
Additional safety guidelines for band saw
1. TO AVOID INJURY FROM UNEXPECTED MOVEMENT, make sure the saw is on a firm, level
surface, and that it is properly secured to prevent rocking. Make sure there is adequate space for
operations. Bolt the saw to a support surface to prevent slipping or sliding during operation.
2. TURN OFF AND UNPLUG the saw before moving it.
3. USE THE CORRECT SIZE AND STYLE OF BLADE.
ALWAYS WEAR EYE PROTECTION THAT CONFORMS WITH CSA
REQUIREMENTS.
FLYING DEBRIS can cause permanent eye damage.
Prescription eyeglasses are not a replacement for proper eye protection.
To Next Page
Loading...
Need help?
General
