ＩＶ． Ｋｎｏｗ ｙｏｕｒ ｂａｎｄ ｓａｗ （ｃｏｎｔｉｎｕｅｄ）
1 Tension knob
2 Blade tension lever
3 Tracking knob
4 Wheel locking blade guide
5 Knob for adjusting the inclination
of the table
6 Table tilt locking knob
7 Dust extraction nozzle
8 Rubbet feet
9 Additional support
10 Control wheel upper blade guide
11 Rip fence
12 Working table
13 On/off switch
14 Upper blade guard
15. Blade
16. Table support assembly
17. Lower blade guide
18. Drive belt
19. Lower wheel
20. Door
21. Upper wheel
22. Motor assembly
23. Upper viewing port
WARNING: FOR YOUR OWN SAFETY, READ THE INSTRUCTION MANUAL BEFORE
OPERATING THE BAND SAW.
1. Wear eye protection.
2. Do not wear gloves, a necktie, or loose clothing.
3. Make sure the saw is on a firm, level surface, and that it is properly secured.
4. Use only the recommended accessories.
5. Use extra caution with very large, very small, or awkward workpieces.
6. Keep your hands away from the blade at all times in order to prevent accidental injury.
9
To Next Page
Loading...
