5
WARNING!
QUICK START GUIDE
COMPLETING THE PLUMBING
Finish installing the necessary
plumbing. Follow the glue
manufacturer’s instructions for
curing time.
4
VERIFYING OPERATION
Check the pump’s operation by filling
the sump with water until the pump
starts. Let it run until it has pumped
down the sump and stopped. Replace
the sump cover.
5
PLUGGING IN THE PUMP
Plug the pump into a 15 A
circuit.
The circuit should be GFCI protected
and dedicated to the sump pump.
Plastic pipe glue is extremely flammable. Follow the glue manufacturer’s instructions
carefully if you are using glued plastic pipe for the discharge pipe.
Install in compliance with all applicable laws, codes, and ordinances. Non-compliance may
cause product failure, property damage, and/or personal injury.
Do not use an extension cord with a sump pump.
Regularly inspect pump inlet and clean away any debris.
To Next Page
Loading...
Need help?
General
