headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
14
model no. 054-6821-2 | contact us 1-800-689-9928
OPERATING INSTRUCTIONS
EDGE GUIDE (
fig 8
)
The router combo kit comes with an edge guide.
This edge guide can be used as an aid in routing
applications such as decorative edging, straight-
edge planing and trimming, grooving, dadoing, and
slotting.
To assemble the edge guide, insert two edge-guide
rods into the holes on the edge guide, and then use
two screws (included) to lock the edge-guide rods
in place.
To attach the edge guide to the fixed or plunge
base, simply insert the edge-guide rods into the
edge-guide mounting slots either from the left or the
right. Adjust the edge guide to the desired position.
For fixed base, secure the edge guide by turning the
quick-release levers toward two handles; for plunge
base, secure the edge guide by turning two locking
nuts clockwise.
DEPTH ADJUSTMENT WITH THE FIXED
BASE
(fig 9)
The fixed base is designed with a fine-adjustment
system. When the bit is lowered to the approximate
position desired (coarse setting), the system can
then be micro-adjusted to the precise depth.
Coarse Adjustment:
Depress the coarse-adjustment button to quickly
lower or raise the cutter bit to an approximate depth
setting.
Fine Adjustments:
The depth-indicator ring located on the fine adjustment dial is marked in 1/256” (0.1 mm) increments.
Turn the fine adjustment dial counter-clockwise 180º (1/2 turn) to lower the cutter bit 1/32” (0.8 mm).
One full turn counter-clockwise 360° (zero “0” to zero “0”) lowers the bit 1/16” (1.6 mm).
The depth-indicator ring may be reset to zero “0” without moving the fine-adjustment dial. This allows
the user to begin adjustments from any reference point desired.
fig 8a
fig 8b
Quick-
release
lever
Edge guide
Edge-guide rod
Screws
fig 9
Coarse-adjustment
button
Fine-adjustment
dial
Depth-indicator
ring
Locking nut
To Next Page
Loading...
Need help?
General
