Page 4-44 2014 MasterCraft Owners Manual • Boat Operations
B O A T O P E R A T I O N S
Location:
All of these options are found on the
tower.
Operation:
1) Lights: The lights
will be either can
lights or blue LED
lights. Either work
from a two-position,
ON-OFF switch on
the dash or driver’s
armrest, depending
on model.
2) Speakers: The speakers operate through
the audio system. See the Video Display
Gauge information for your model in
this Owner’s Manual for instructions on
how the volume is controlled.
3) Board Racks: When board racks are or-
dered, there are three available options:
a) wakeboard storage on upper and low-
er arms;
b) wakeboard upper, and wakesurf low-
er; or
c) slalom ski storage upper and lower.
Note that, regardless of the type
of board or ski, it should be securely
clamped (or secured with a bungee cord
on the ZFT0 tower) so that board/ski
does not come loose or disengage from
the rack during boat operations. DO
NOT attempt to place the wrong type of
board within spokes (i.e., slalom skis in
a board rack) because the t will be im-
proper. Resulting loss or damage to the
board, or injury to individuals, is not the
responsibility of the manufacturer.
On the ZFT5 tower, the rack location
can be moved by backing off (unscrew-
ing) the adjustment knob all the way to
the top of the housing prior to moving
the board rack. There will be some slack
and slight movement as the knob is un-
screwed, but if the board rack is moved
at that time, failure is likely. Either the
internal bolt will bend and become unus-
able, or the aluminum housing may be
distorted and then unable to accept the re-
tightening of the knob back into place to
secure the board rack. These are the only
two positions that the knob should ever
be in. It is also important that the knob be
re-secured anytime the board rack is read-
justed. Otherwise, the rack could move or
shift unexpectedly, making anyone close
to the rack vulnerable to being struck by
the teeth of the rack or any boards that are
held by the rack.
Troubleshooting:
1) Lights: If the lights do not work when the
switch is turned ON, check the main cir-
cuit breaker panel to determine whether
the circuit has tripped, and re-set if it has.
If the circuit continues to trip or if the cir-
cuit is on but the lights still do not work,
take the boat to an authorized Master-
Craft dealer for attention.
2) Speakers: If the audio speakers on the
tower do not work, verify electrical
circuits by checking the main circuit
breaker panel. Re-set if it has tripped. If
it still does not work, take the boat to an
authorized MasterCraft dealer for repair.
3) Board Racks: If boards will not sit se-
curely in place, and it is determined that
the proper board for the proper rack is in
use, do not leave the board in the rack.
Take the boat to an authorized Master-
Craft dealer to determine the underlying
cause.
To Next Page
Loading...
Need help?
General
