DANGER: Always remove the
battery when changing the blade.
When replacing the blade, make sure the
replacement blade is 6 1/2" (16.5 cm) in
diameter and is rated for at least 7,000
RPM. Installing an incorrect blade will
result in possible injury and poor cutting
action.
Always make sure the blade guard is
functioning properly. A broken guard may
cause serious injury.
After changing a blade or making
adjustments, make sure the blade clamp
screw is securely tightened. Loose blades
and adjustment devices will be violently
thrown.
Never touch the blade during or
immediately after use. After use the blade
is too hot to be touched by bare hands.
Never use dull or damaged blades. Sharp
blades must be handled with care.
Damaged blades can snap during use.
Dull blades require more force to cut the
workpiece, possibly causing the blade to
break.
Battery packs and chargers must be
purchased separately.
This circular saw has been designed to be
powered by one of the following battery
packs:
● 18 V Nickel-Cadmium #54-3102-2
● 18 V Lithium-ion #54-3100-6
WARNING: Only use the battery
packs listed above to power this tool.
Using any other battery pack could
cause serious injury or damage the
tool.
Both battery packs can be charged using
one of the following chargers:
● 14.4 V / 18 V LED Diagnostic charger
#54-3103-0
● 14.4 V / 18 V LCD Diagnostic charger
#54-3101-4
WARNING: Only use the battery
chargers listed above to charge the
battery packs listed above. Charging
any other batteries may damage the
charger and possibly cause serious
injury.
WARNING: Follow all safety rules
and warnings included with the battery
pack and charger purchased for use
with this tool. Failure to follow those
safety rules and warnings may result in
serious injury or damage to the charger
and battery pack.
Never dispose of defective batteries with
your household waste. Always recycle
defective batteries in accordance with your
local municipal policies.
To Next Page